If you have an accurate frequency counter, and it really needs to be extremely accurate, then you can also measure the reference frequency out from the IC-7800. Cost is about 75-80 bucks to get you a really accurate frequency standard. This can be the standard derived from the GPS system or something like this. Win4Icom has the ability to adjust and control the audio and IF levels and as well. You can input a reference 10 MHz on the rear panel. To achieve maximum audio quality it is important to adjust the DSP settings. IC-7300, IC-7610, IC-7600, IC-7700, IC-7800, IC-7850/1 and IC-9700. Open the Logger+ Audio Setup window from the Config > Logger+ Audio Setup menu item. Second Hand Icom IC View cart Icom IC-765 CAT Control / Programming Cable has been. If it doesn't then something has gone wrong somewhere (duh!! You think?). If youre looking for audio transceivers that offer noise-blanker. The frequency adjustment on the IC-7800 should give you some definite change in frequency as you monitor it. For the TS-590S you can get a TXCO and should be able to adjust it to 2-3 Hz and have it remain there on the 15 MHz check with WWV. Adjust your transmit audio by watching your compressor level. It mathematically goes farther out as you increase frequency. It seems though, Im never happy with my transmit audio settings. Following the design linage of the IC-7800, the IC-7851 uses a dedicated DSP unit for the. I have a TS-590S and it's off at 34 Hz on the 10 MHz WWV check point and is off by 42 Hz on the 15 MHz check. I know some folks are just wanting their rig to read exactly the correct frequency.
That's not much and is well within the tolerance of the IC-7800.ĭo you have some specific reason why an accurate display is needed? You posted the frequency is off by 20-30 Hz.
0 kommentar(er)
